Assembly
V.. / NV.. / CV..
en-18
2022-D059517
Revision: 05
5.3.3 Mounting with threaded bores
5.4
Components mounted to the output side
The output side has different shapes depending on the product type:
- Smooth shaft
- Shaft with key
- Splined shaft (DIN 5480)
- Slip-on shaft / hollow shaft / hollow shaft interface / flange hollow shaft
- Flange
- with mounted output pinion
For details on how to mount the
slip-on shaft / hollow shaft / hollow shaft interface
, refer to
the instructions in Chapter 5.4.1 "Mounting with shrink disk".
For details on how to fasten the
flange / flange hollow shaft / keyed hollow shaft
, refer to
the instructions in Chapter 9.3 "Specifications for mounting to the output side".
WITTENSTEIN alpha GmbH
offers corresponding mounting kits for gearboxes in
Hygienic
Design
. The separate instructions "Hygienic Design Instruction Sheet, Mounting Kit" (Doc. no.
2022–D062618) are valid for this. The manual will be provided by our Sales / Customer Service
department on request. Please always provide the serial number.
We recommend doing without washers as long as the
material of the screw surface features sufficient interface
pressure.
Fasten the gearbox to the machine with the fastening screws
through the threaded bores [M].
Tension during assembly may damage the gearbox.
Mount the mounting parts onto the output shaft / output flange without
using force.
Never attempt to assemble by force or hammering!
Only use suitable tools and devices for assembly.
Make sure not to exceed the maximum permissible static axial forces on
the output bearing (see Chapter 9.3 "Specifications for mounting to the
output side") when pulling or shrink-fitting a mounting part onto the output
side.
M
