Wittenstein Alpha LUC+125, Operating Manual, Page: 15 / 35

LUC
+
125, 24 V, time-controlled
Revision: 01 1000088471 en-13
- The lubricator is time-controlled and works time-based via the integrated microelectronics and
must be connected to a 24 V DC power supply. The lubricator cyclically delivers a defined
volume of lubricant from the cartridge to the outlet.
- The relubrication volume is defined in months by the emptying time setting of the cartridge.
Emptying times
t of 1...36 month(s) and a number of cycles c of 1…10 can be set.
- The single-use changeable cartridges with a lubricant capacity of 125/250 cm3 ensure
controlled and consistent quality of lubricants and are filled without any trapped air. The
lubricator offers a reliable supply to lubrication points and prevents downtime of machinery.
This version of the lubricator is designed for grease lubricants.
- The lubricator cannot be used without an external 24 V DC power supply. The lubricant
cartridge is included in the scope of delivery and already installed in the lubricator.
- The respective modes of the lubricator are shown on the display, which also enables
recognition of the status by LEDs in different colors.
- The use of cartridges of a different size requires consultation with WITTENSTEIN alpha
GmbH .
- In case of any questions regarding your applications and the correct settings for the lubricator,
please contact
WITTENSTEIN alpha GmbH .
6.1.2 Factory settings
Parameter
Program menu
Designation Factory settings Result
t Emptying time 6 6 months
c Number of cycles 2 2 pump strokes per
lubrication
(0.15 cm
3
/stroke)
Tbl - 5 Factory settings program menu
Parameter Designation Factory settings Result
P Maximum pressure 50 50 bar
Pu Control mode 0 Time control active
U Cartridge size 12 Cartridge 125 cm
3
E Inverted output signals 1 Permanent high signal in
case of error
L Empty cartridge signal 1 Permanent high signal in
case of error
F Feedback signal 0 Low signal when motor is
running
Parameters P, Pu, U, E, L and F may only be changed after consultation.
If you have any questions, please contact WITTENSTEIN alpha GmbH Sales /
Customer Service.
Tbl - 6 Advanced programming factory settings