Wittenborg FB 7100 PLUS, Operator'S Manual

Page: 6 / 88

Safety
2 FB 7100 PLUS 10.2011
SAFETY
•
Before starting installation and using the
machine, it is first necessary to carefully
read and understand the instructions
contained in this manual, as they offer
important information on installation
safety, operating instructions and
maintenance.
•
This manual describes the loading and
routine maintenance operations which are
carried out in areas of the machine
accessible with simple use of the door
key, without using any other tools.
•
The vending machine may not be subject
to frost during operation, storage and
transport.
- If there is the risk of frost in the area of
the installation site of the machine,
voltage to the machine may not be
disconnected.
- If there is the danger of damage due to
frost, the service technician must check
and replace boiler, hoses and valves if
required prior to reconnecting the
vending machine and he should
additionally carry out a functional test.
•
The vending machine may not be installed
outside.
•
The vending machine should only be
installed and repaired by qualified
personnel, who are trained in the correct
use of the machine according to the
standards in force and who have the
specific knowledge of the machine
functioning from a point of view of
electrical safety and health regulations.
•
Safety devices must not be bridged or put
out of function.
•
The vending machine must be connected
to the drinking water line and to the
electric line in compliance with local
regulations.
•
The vending machine has to be placed in
a horizontal position.
•
The vending machine must be connected
to a secured electric circuit.
We recommend to install a fault current
safety switch. The connections must be
made using an earthed safety plug socket
complying with valid regulations.
•
After the machine has been installed, the
power supply plug must be accessible.
Never touch the power supply plug
with wet hands nor plug it in if the
plug itself is wet.
The liquids dispensed by the vend-
ing machine are very hot! To pre-
vent scalding, hands (and/or other
parts of the body) must be kept
away from the outlets while drinks
are being prepared and dispensed.
•
If the power supply cable of the vending
machine is damaged it may only be
replaced by a service technician.