Measuring
mode
Information
Standard
Standard measuring mode for watches with
Swiss lever escapement.
Rate
Measuring mode for the rate measurement
only of watches with cylinder, duplex or chro-
nometer escapement, in addition to watches
with unusual beat noises.
Special 1 co-
axial
Measuring mode for watches with co-axial
escapement.
Special 2 AP
Measuring mode for watches with AP
escapement.
Special 3 – 9
Not active (reserved)
Determining the escapement type
You can find out the escapement type of the
watch for testing by consulting the watch man-
ufacturer.
Information in the software manual
Further information on the measuring modes
can be found in the corresponding software
manual.
The
“Chronoscope Service”
display software provides two
possible display modes for the ChronoMaster and Chrono-
Master PRO versions:
•
Continuous diagram recording
•
Vario
The following display modes are also available for the Chrono-
Master PRO version:
•
Trace
•
Sequence
•
Polar
•
Scope 1, Scope 2
All display modes are available when ChronoMaster Air is
used.
Display modes
24.03.2021
Precision measuring device ChronoMaster / ChronoMaster Air
10
Summary of Contents for ChronoMaster
Page 46: ...Appendix 24 03 2021 Precision measuring device ChronoMaster ChronoMaster Air 46 ...
Page 48: ......
Page 50: ......
