1 SLAVE DALI Fixture Controller
Radiar AFD1
WARNING AND GUIDELINES!!!
DO NOT INSTALL DAMAGED PRODUCT!
This product has been properly packed so that
no parts should have been damaged during transit. Inspect to confirm. Any part
damaged or broken during or after assembly should be replaced.
WARNING :
TURN THE POWER OFF AT THE CIRCUIT
BREAKER BEFORE WIRING
Required tools &
supplies
INSTALLATION INSTRUCTIONS
Installation Steps
Read and follow all safety instructions!!
Do’s
Installation should be performed by a
qualified electrician
Don'ts
Don't use outdoors
Installation shall be in accordance with
all applicable local and NEC codes
Avoid input voltage exceeding
maximum rating
Turn the power OFF at circuit breakers
before wiring
Don't disassemble the products
Observe the correct polarity of output
terminal
-
Electrostatic Discharge (ESD): ESD can damage product(s). Personal grounding
equipment should be worn during all installation or servicing of the unit
Do not stretch or use cable sets that are too short or are of insufficient length
Do not modify the product
Do not mount near gas or electric heater
Do not change or alter internal wiring or installation circuitry
Do not use product for anything other than its intended use
WARNING: Risk of Product Damage
Screwdriver
Verify that supply voltage is correct by comparing it with the product
information
Make all electrical and grounded connections in accordance with the National
Electrical Code (NEC) and any applicable local code requirements
All wiring connections should be capped with UL approved recognized wire
connectors
All unused wiring must be capped
WARNING - Risk of Electric Shock
INSTALLATION AND QUICK START SHEET
Product Overview
Radiar AFD1 is designed to control
AC-powered lighting fixtures supporting
Digitally Addressable Lighting Interface.
It provides ON/OFF or dimming/tunable
control for 1 LED driver
It is a part of Lumos Controls
ecosystem, which includes controllers,
sensors, switches, modules, drivers,
gateways, and analytical dashboards.
1. Turn off the power before wiring and installing the device
2. The controller with a compact formfactor can be installed anywhere within the light fixtures, or within junction boxes. The screw hole available on the controller can be
used to fix it firmly.
3. To power the controller, connect the AC Line (Black) and Neutral (Wires) wires from the controller to the mains supply
4. To control the DALI driver, connect the DALI lines to the DALI+ (Purple color) and DALI- (Pink color) wires in the controller. *DALI is polarity insensitive
Wire nuts
Specifications
Value
Remarks
Input Voltage
Rated Input voltage
@ 230 V
Input Current
Surge Transient Protection
4kV
L-N, Bi wave
90-277VAC
10mA
Active Power
Power Consumption
2W
In an open office environment
(Line of Sight)
Connection Distance
(Device to Device by Mesh)
30m
Frequency Range
_
_
With 150mm external
wire antenna
Tx Power
2400-2483MHz
8dBm
Rx Sensitivity
-92dBm
_
Bus Supply Voltage
2mA
11-13VDC
_
Bus Supply Current
_
_
_
Dimming Range
100%
Ambient Temperature
-20-50ºC
Relative Humidity
20-85%
L x W x H
Dimensions
1.7 x 1.4 x 0.8 In
43 x 35 x 20 mm
FCC ID: 2AG4N-WCAD1N
