How to use this Manual
Safety Considerations:
This information that must be read and understood by all persons installing, using, or
maintaining this equipment. This manual is designed to aid personnel in the correct
and safe installation, operation, and maintenance of the systems described.
Personnel must consider all actions and procedures for potential hazards or
conditions that may not have been anticipated in the written procedures. If a
procedure cannot be performed safely, it must not be performed until appropriate
actions can be taken to ensure the safety of equipment and personnel. The
procedures in this manual are not designed to replace or supersede required or
common-sense safety practices. All safety warnings listed in any documents
applicable to equipment and parts used in or with the system described in this
manual must be read and heeded before commencing work on any part of the
system.
NOTE: Refer to all ATEX, CSA, IECEx, NEC, NFPA and FM
certificates for any Special Conditions of Use. If the sign “X” is
placed after the certificate number, it indicates that the equipment
or protective system is subject to special conditions for safe use
specified in the schedule of the certificate.
NOTE: Review all material and safety information in this manual and
install in accordance with this document and all other applicable
ATEX, CSA, IECEx, NEC, NFPA70 Installation Methods and FM and
National standards.
Warning- Failure to follow appropriate safety procedures or
appropriate use of the equipment described in this manual can lead
to injury of personnel or equipment damage.
Warning – Explosion Hazard– Do not open equipment unless power
has been removed or the area is known to be non-hazardous.
General Manual:
This manual is intended to be used in conjunction with installed equipment manual
from internal equipment manufacturer.
Note: In the event of a conflict between the requirements of this general installation
manual and the internal equipment manual, the safety and installation procedures
described in this manual shall take precedence.
8
Summary of Contents for TNO-X6072EPT1-Z
