7. Ensure threads and gaskets are free of dirt and debris.
8. Reinstall
TNO-X
nnnn
EPT1-Z
end cap by hand to tighten by turning clockwise until hand tight and
gasket is seated
9. Tighten both set screws on the end cap and lens cap ends of the housing.
Figure 8.
Figure 9.
Set Screw (same on lens cap)
INSTALLATION
20
10. Install
HT-F1XX-WM
wall
mount
(optional accessory)
.
11. Remove Protective film after installation. If protective film is not removed in timely manor damage
to lens is likely to occur with UV exposure
12. Apply power. For internal equipment startup procedures, setting changes, and troubleshooting
guides
,
reference the
Hanwha camera
manual included with the “
TNO-X
nnnn
EPT1-Z
" Series
Cameras. If the included copy is lost, please contact [email protected]
or
for a PDF copy.
Figure 10.
Summary of Contents for TNO-X6072EPT1-Z
