Wisenet SmartCam D1, Installation Manual

Page: 11 / 16

11
5
Optional Step for Extending Power Supply (Requires Power Extension Kit):
a
If existing wire is too short, use the Power Cable Extender and connect the flat
circular end of it to the terminal, then screw the terminal back on.
b
Pull the orange levers on the terminal blocks up.
c
Insert the existing cable from the wall to one of the slots and push the orange
lever back down.
d
Insert the new power cable from the doorbell to the other slot and pull the lever
back down in place.
e
Repeat this process for the other side.
6
Mount and secure your doorbell.
a
Insert the anchors into the holes completely.
b
Tuck the wires attached to the doorbell back into the wall and align the two holes
on the doorbell with the holes in the wall.
c
Screw the SmartCam D1 tightly into the wall.
k `
Make sure to remove the faceplate attached to your SmartCam D1 to access the mounting holes.
Mounting the SmartCam D1
RESET
RESET