Wisenet QND-7012R, User Manual

Page: 9 / 40

English _
9
!
OVER
VIEW
Item Description
a
Inside cover
Protective cover for the main body.
b
Illumination Sensor Detects incoming light to control the IR LED.
c
Lens Lens for the camera.
d
IR LED These infrared LED’s are controlled by the illumination sensor.
e
Reset Button
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J If you reset the camera, the network settings will be adjusted so that DHCP can be
enabled. If there is no DHCP server in the network, you must run the Device Manager
program to change the basic network settings such as IP address, Subnet mask,
Gateway, etc., before you can connect to the network.
f
Test monitor out port
Output port for test monitoring the video output. Use the test monitor cable to connect to a
mobile display and check the test video.
g
Alarm I/O Port
ARM-IN Used to connect the alarm input sensor or external day/night sensor.
ARM-OUT Used to connect the alarm output signal.
GND These are common ports to connect alarm input/output signals.
h
Microphone hole Microphone is embedded.
i
Power Port
Port for power terminal block.
j
Micro SD Card slot Compartment for the Micro SD card.
k
Network Port Used to connect the PoE or Ethernet cable for network connection.
AT A GLANCE (QND-7082R)
Appearance
Item Description
a
Dome cover
Case cover used to protect the lens and the main unit.
b
Camera Case Housing part that covers the camera body.
c
Microphone hole Microphone is embedded.
a
b
c