installation & connection
10_
installation & connection
installation & connection
INSTALLATION
J
`
This camera is waterproof and in compliance with the IP66 spec, but the jack connected to the external cable is not. You are
recommended to install this product below the edge of eaves to prevent the cable from being externally exposed.
Precautions before installation
Ensure you read out the following instructions before installing the camera:
•
Select an installation site that can hold at least 5 times the camera’s weight.
•
Stuck-in or peeled-off cables can cause damage to the product or a fire.
•
For safety purposes, keep anyone else away from the installation site.
And put aside personal belongings from the site, just in case.
•
If the product is installed with excessive force, it may cause damage to the camera due to malfunction.
Forcing assembly using non-compliant tools may damage the product.
•
Do not remove the lens module while the power is on.
•
The image can be covered up by the camera case depending on the angle.
Disassembling
Remove the dome cover by unscrewing the four screws in a
counterclockwise direction using the supplied Torx L Wrench.
`
Note that it is not necessary to loosen the screws completely.
Mounting lens module
1.
Align and fasten the connector of the lens module with
the connector of the camera body.
J
`
You are recommended to avoid touching the lens separately,
as it is shipped from the factory with the focus adjusted
during the manufacturing inspection.
2.
Complete the lens mounting process.
