SAGE SERIES L75i
WISDOMAUDIO.COM
9
For the purposes of this manual, we will assume that you have already connected the
Stereo/Surround System Controller as per the instructions found in its manual. As such,
you should have signal coming from your source component(s) to a preamp/ processor,
the signal output is split into low and high sections, with the low section going to one or
more Wisdom Audio SA Series amplifiers, and the high section going to another
amplifier, which will drive the planar magnetic panels.
Connect the outputs of your Wisdom Audio SA-series amplifier to the appropriate
woofer sections, taking care to get both the channel assignments and the polarity
correct. Connect the positive (+) terminals on the SA Series amplifier to the positive (+)
terminals for the woofer on the loudspeaker; likewise, connect the negative (–)
terminals on the amplifier and the speaker, respectively.
Next connect the outputs of your chosen amplifier for the midrange/treble to the Sage
L75i planar sections in a similar fashion, taking care with both channel assignments and
polarity.
Care and Maintenance
To remove dust from the front of your L75i, use a feather duster or a lint-free soft cloth.
To remove stubborn dirt and fingerprints from the grille, we recommend isopropyl
alcohol and a soft cloth. Lightly dampen the cloth with alcohol first and then clean the
grille of the L75i with the cloth. Do not use excessive amounts of alcohol –there is no
need for the cloth to be wet; merely damp is better.
Never attempt to clean the drivers themselves.
CAUTION!
Do not touch the surface of the planar magnetic drivers, under any circumstances.
The thin film has been carefully pre-tensioned at the factory; any subsequent contact
can only damage it.
