28
WPS-550-DOM-IP Installation Manual
9.3. Network IP Settings
• Navigation: Log in as an administrator.
From Home Screen, click “Config” button in top right corner, then click “IP Settings”
in left column.
9.3.1. Basic IP Settings
9.3.1.1. IP Assignment
Important! These settings are required for the camera to communicate correctly at all times. Use only static
IP addresses. Contact the network administrator if you are unaware of what the settings should be or cannot
access the network for setup.
1
DHCP/Static
Select IP address type. Set to DHCP by default so that network settings are issued by the router.
Change to a static IP address type to make changes to the IP settings. (All IP Assignment fields remain
grayed out until Static is selected.)
IP Address
Current IP address of the camera. Enter a new address here to change the static IP address.
The address used must also be correctly configured for reserved use in the router. See router
documentation to correctly reserve a static IP address.
Subnet Mask
Subnet mask of the camera’s subnet. (For smaller networks, usually 255.255.255.0, found in the router)
Gateway
IP address of the router as seen by the network. (Found in the router.)
DNS 0
Domain Name Server of the camera network. (Found in the router)
DNS 1
(Optional by network) Second Domain Name Server for the camera network. (Found in the router)
If no secondary DNS is set, use 0.0.0.0
Click “Apply” at the bottom-right of the page to save modified settings.
1
2
3
4
6
8
7
5