12
WPS-550-DOM-IP Installation Manual
7.3. Aiming the Camera
A. Connect the BNC Test Adapter to a monitor or WPS-CCTV-TESTER video in.
B. Connect a power supply to the secondary power connection on the camera (if main power connection is not active).
C. Adjust the camera’s 3-axis angle so the lens points in the desired direction.
Warning:
The lens angle must not exceed 67˚ off the center axis. This will prevent IR reflection inside the dome from causing a
halo effect in the camera image at night.
Ma
xi
mum Cam
e
ra A
ngle
67.0°
67.0°
D. Disconnect the WPS-CCTV-TESTER or monitor and power supply from the local test connections and push them back into the
housing.
7.4. Closing the Camera Dome
Recommendation:
Before replacing the dome we recommend that a new silica gel pack be inserted into the camera to ensure that
any moisture present will be removed.
A. Ensure that the lens gasket is properly fitted to the lens assembly.
B. Replace the dome cover to the dome base, and make sure the screws on the dome cover are tightened securely.
C. Remove the warning sticker and protective film.
Warning:
The dome must provide a tight fit around the rubber lens gasket to avoid IR reflection off of the dome resulting in a halo
effect in the camera image at night.
L
en
s Rubb
e
r Gask
et