WPS-300-NVR Installation Manual
Pg. 29
www.snapav.com Support: 866.838.5052
12.1- PPPoE
12.1.1- PPPoE Settings
Point-to-Point Protocol Over Ethernet (PPPoE) is a network protocol primarily used DSL (Digital Subscriber
Line) providers and modems. This protocol requires a login to connect to the modem even when a router
is used. Configuration of these settings is not required to operate the NVR on a standard network.
PPPoE
Enable to allow the NVR to access PPPoE for sending Email or saving to FTP.
Username
Login name from the service provider
Password
Password for the above username.
Send Mail
Enable to send an Email when the PPPoE is dialed.
Subject
Enter text to use as the subject line of the email.
12.1- DDNS
12.1.1- DDNS Settings
DDNS (Dynamic DNS) maps Internet Domain Names to an IP through services like Wirepathdns.com.
When configured, the NVR is available remotely via a simple easy to remember name such as
JonesIPNVR.Wirepathdns.com
Configuring DDNS is not required for remote access, but avoids having to pay for and remember a static IP
address from the ISP.
See Section
6- Configure NVR for Remote Access
for details on configuring remote access.
DDNS
Enable to allow configuring and using a DDNS service.
Provider
Name of the DDNS service provider.
Hostname
Name to use when accessing the NVR remotely.
Example: JonesIPNVR.
State
Current connection status of the DDNS service.
This field will update automatically shortly after entering and applying a Hostname. . It can
also be updated by selecting any other settings page and re-selecting the DDNS page.
