WPS-300-NVR Installation Manual
Pg. 11
www.snapav.com Support: 866.838.5052
6.2.2- Rear Panel
HDMI OUTPUT
ETHERNET
VGA OUTPUT
eSATA
12V DC 5A
INPUT
1
2
3
4
6
5
7
1. DC Power Connection
Connect to the included 12V DC 5A Power Supply.
2. ESATA Port
Connect and external ESATA HDD.
3. Ethernet Port (10/1000Mbps)
Connect to a 1Gbps router or switch.
4. RS485 / Alarm In / Relay
Connections for RS485, Alarm Inputs, and Relay In and Out for triggering actions of the NVR.
5. Main Monitor Out (VGA)
Connect to a VGA display for viewing of NVR content.
6. Main Monitor Out (HDMI)
Connect to an HDMI display or Flat Panel TV for viewing of NVR content.
7. Cooling Fan
Cools unit during operation. Do Not Block.
6.2.3- Control Connections
HDMI OUTPUT
ETHERNET
VGA OUTPUT
eSATA
12V DC 5A
INPUT
1
2
3
4
1. RS-485 Connections
This connection is for future use.
2. Alarm Connections
Connect to motion sensors, or door switches or other devices to trigger an event
for a particular Encoder.
Configuration is required; see section
Max Voltage: 33v DC 50mA
3. Relay Connections
Connect to devices to control from the GUI, or when an event occurs.
Configuration is required, see section.
4. Ground (GND)
Ground connection for Alarm Connections.
