TReX User Manual v2.14 Firmware
Viewing Multiple TReX Unit IO on the MASTER Unit.
The MASTER on the IO screens can view all system inputs and outputs without the need for a
SCADA application. This is useful for debugging and installation.
Shown in this case is the number “01”, followed by “069”, where“01” in this case is the UNIT
ID in the system. The “069” is a “link fail” counter used to determine loss of communication
for a unit. This number is reset whenever a new message is decoded from a SLAVE unit.
Pressing the DOWN button will cycle through all the remote UNIT IDs in the system,
displaying all system IO, link states, temperatures and battery voltages.
© WTE Limited, 2018 – Christchurch New Zealand
Page 106 of 158
