SERVICE MANUAL & ICA
10000 AMPHIBIAN FLOATS ON AIR TRACTOR AT-802A
Page 62
Revision U
P/N 1002545
The Rite Angle 111b AOA system is installed in this aircraft. A separate manual is provided for installation and
operation of this system. This system is not a primary aircraft instrument and is for advisory only.
9.1 GENERAL
CHAPTER 9 – ANGLE OF ATTACK SYSTEM
The AOA system is pre-programmed for the AT-802A aircraft on 10000 floats. The wiring schematic is on figure
9.4. The manual for all other instructions is in the manufacturer’s manual.
The vane setting should be 7.8 ° nose up from aircraft leveling point when 1st green light just comes on.
Measurements were taken from flat section of vane. Figure 9.4A shows resistances in ohms (Ω) across the P-12
connection on the J6 module box. These readings are approximates only and vary from installation to installation,
however they provide a good reference for different flap settings in ensuring the flap sensor is calibrated.
9.2 MAINTENANCE
