SERVICE MANUAL & ICA
10000 AMPHIBIAN FLOATS ON AIR TRACTOR AT-802A
Page 112
Revision U
P/N 1002545
15.2 OVERGROSS LANDING INSPECTION CHECKLIST
REQUIRED IN INSPECTION
MECHANIC
RT.
LT.
Landing
Gear
Systems
Nose
Landing
Gear
Nose Wheels – Inspect for wear,
damage, and loose attaching
hardware to include axle
Loose attaching hardware will
require further inspection for
deformation and hole elongation
Nose Tires –Inspect for wear,
pressure, and condition
See Servicing Section in
Maintenance Manual for proper
nose tire pressure
Nose Wheel bearings – Inspect
for bearing and seal damage
Nose Springs – Inspect for
cracks around attaching
hardware, material delamination
Pivot Block and Nose Forks
– Inspect for bending, cracks,
loose hardware
Loose attaching hardware will
require further inspection for
deformation and hole elongation
Nose gear Trolley – Inspect for
evidence of impact damage near
attach points, and all attached
linkages to include over center
down lock mechanism to include
trolley block and/or trolley axles
When damage is found accomplish
gear swing, looking for nose gear
binding due to component damage
and replace as needed.
Nose gear ram assy. and Rod
End – Inspect for evidence of
damage and proper functionality
See Service Manual for how
to properly perform retraction/
extension test
Main
Landing
Gear
Main Wheels – Inspect for wear,
damage, and loose attaching
hardware to include axle
Loose attaching hardware will
require further inspection for
deformation and hole elongation
Main Tires – Inspect for wear,
pressure, and condition
See Servicing Section in
Maintenance Manual for proper
nose tire pressure
Main Wheel Bearings - Inspect
for bearing and seal damage
Drag link, Tube, and Axle Assy. –
Inspect for damage, attach point
failure, loose/sheared hardware