WINZO
WINZO
WINZO
WINZO
WINZO
WINZO
1.Insert the fixing bolt set into the
seat holes of pan.
2. Using a screwdriver to temporarily
tighten the bolts. (Do not full tighten).
Adjustability is required at this step
in order to position the seat in following
steps.
3.Place the seat vertically,align holes
to pins and press down insert.
4. Close the toilet seat onto pan,
adjust until the seat is located in a satisfactory
position.
5.Push two release buttons to release the seat.
Carefully lift the seat so that the postion of the
seat will not shift,then firmly tighten the screws.
6.Place the cover caps over the fixing base.
And put the toilet seat back on the pins.
CLEANING
The toilet seat may be removed for cleaning -depress two release buttons and lift
up. (see step 5)
Clean only with a soft cloth or sponge usingwarm water and mild soap or detergent.
Do not use any abrasive cleaning materials.
Do not use any solvents or corrosive liquids.
Cover cap
x2
Fixing Bolt sets
x2
Toilet seat x 1
Fixing bolt sets assembly
(normally it has been assembed)
1
2
3
4
5
6
Screw
Washer
Fixing base
Flex-washer
Expansion fitting
Pin
$obѴ;|";-|mv|-ѴѴ-ঞommv|u1ঞom
3/3
