Wintriss SmartPAC PRO Servo, User Manual

Page: 87 / 228

SmartPAC PRO Servo User Manual 1147100
Chapter 4
– Initialization Mode
87
4. Highlight the SENSOR RESOLUTION item. Press ENTER until the setting you want is
displayed, referring to Table 4-2 for available options.
NOTICE
DO NOT enter the OFFSET VALUE field until you have set the Zero Value and Upper Limit.
5. Highlight the ZERO VALUE item.
6. Set the ZERO VALUE field in one of the following ways:
•
If you are using a Balluff sensor, this item should be set to zero (0). To change the setting,
press ENTER, and when the Numeric Entry window displays key in zero and press ENTER.
Your entry displays in the ZERO VALUE field.
•
If you are using an MTS sensor, position the ram at Bottom Dead Center (BDC) and at the
Lower Limit of its Shut Height adjustment, then press Save Zero Position. That position, in
counts, is displayed in the ZERO VALUE field. The displayed value should be greater than
1,000 counts. If it isn’t, the magnet is positioned outside the sensor’s range. Move the
transducer down so that the magnet is positioned within the sensor’s range, then press Save
Zero Position again.
7. Highlight the UPPER LIMIT item.
8. Set the UPPER LIMIT value in one of the following ways:
•
Switch to Run mode (see page 160 for instructions). Inch the ram to Top Dead Center (TDC)
and adjust the Shut Height to its Upper Limit. Return to this screen, and press Save Upper
Limit. The absolute reading reported by the linear sensor displays in the UPPER LIMIT field.
or
•
Press ENTER, and when the Numeric Entry window displays, key in the value you want,
using the numeric keypad or the Up (

) and Down (

) cursor keys, and press ENTER. The
value you specified displays in the UPPER LIMIT field.
9. Highlight the OFFSET VALUE item.
NOTICE
With firmware versions V6.0 or higher, there is no limit for the Offset Value.
10. Press ENTER, key in the value you want in the Numeric Entry window, and press ENTER. The
value you specified displays in the OFFSET VALUE field.
11. When you are finished, press Back to return to the Main Initialization Menu.
TOOL INFORMATION
(INITIALIZATION
– TOOL INFORMATION)
The TOOL INFORMATION item on the Main Initialization Menu allows you to set up a name, unit
of measurement, and number of decimal places for up to six items you wish to document for each
tool. You enter specific values and up to thirty characters of special information for each tool in