Wintriss SmartPAC PRO Servo, User Manual

Page: 167 / 228

SmartPAC PRO Servo User Manual 1147100
Chapter 6
– Run Mode
167
NOTICE
When the Total Hits counter reaches its preset value, a flashing message, “Total Hits Preset,”
appears in the Status Box at the top of the screen. To clear this message, set the Total Hits preset
to zero (0), then reset this value to the desired quantity. See
COUNTERS , page 114.
DIE PROTECTION (Optional)
(RUN
– DIE PROTECTION)
CAUTION
Some Servo presses are capable of hitting the same part more than once at Bottom Dead Center
(BDC) before returning to the top of the stroke. You will have to note the angle ranges at which
repeated strokes occur. Any cams programmed within these ranges will actuate once for each hit.
Die protection ready signals programmed within these ranges will expect sensor actuation once for
each hit. If this is not feasible, please contact Wintriss Tech. Support to learn about new advanced
features.
Failure to comply with these instructions could result in property damage.
NOTICE
For help with the Die Protection Menu and the screens accessible from it, press the HELP key
when the applicable screen is displayed.
This item, which appears on the Main Run Menu only when DiProPAC 8 or DiProPAC 16 is
installed, allows you to adjust the Ready signal for green sensors and the stroke preset for green
special sensors. Make adjustments via the Die Protection Menu (see Figure 6-10), which displays
when you select DIE PROTECTION on the Main Run Menu. You can also view a summary of
information for all your sensors and a graphical display of sensor status from this menu.
Figure 6-10. Die Protection Menu (Run Mode)