Wintriss SmartPAC PRO Servo, User Manual

Page: 129 / 228

SmartPAC PRO Servo User Manual 1147100
Chapter 5
– Program Mode
129
This screen allows you to set the Auto Enable by Sensor counter, which specifies the number of press
strokes necessary to re-enable the sensor following a DISABLE SENSORS command (see
SENSOR
ENABLE/DISABLE & STATUS (Optional) , page 156, and DISABLE (ENABLE) SENSORS , page 163)
To set the Auto Enable by Sensor counter, do the following:
1. On the Auto Enable by Sensor Counter screen, select the value in the AUTO ENABLE
COUNTER field. The Numeric Entry window displays.
2. Key in the value you want (maximum is 99), following the directions in the window, and press
ENTER. The value you keyed in displays in the AUTO ENABLE COUNTER field.
3. Press ENTER to display the Sensor Type screen (see next section).
Setting Sensor Type
After you select a sensor name and, if AUTO ENABLE BY SENSOR is the Initialization setting,
specify the Auto Enable stroke count, the Sensor Type screen, Figure 5-25, displays with the name
you selected for the sensor shown at the right of the Status Box beneath the sensor number.
Figure 5-26. Sensor Type Screen
You can select one of six types of sensor (see Sensor Types , page 122, for details), or you can select
NOT USED, in which case that sensor is not programmed for the tool.
To set the sensor type, do the following:
1. Select the sensor type you want. For all selections except UNUSED, the Sensor Stop Type screen
(see next section) displays with the sensor type you selected displayed at the right of the Status
Box beneath the sensor name.
If you selected UNUSED, you are returned to the Die Protection Sensor Menu. The name of the
sensor you started to program is reset to SENSOR 1, SENSOR 2, etc.