Wintriss SmartPAC 2, User Manual

Page: 31 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Introduction 1-3
the test provide the stopping time (Ts) value specified in both OSHA 1910.217 and ANSI
B11.1-2009 (see Appendix A).
•
Inputs for multiple Shadow light curtains. WPC 2000 tests up to two Shadow light curtain
inputs every time that the press is started and stopped.
•
Micro-inch, a feature that allows you to set the amount of time that the Dual Safety Valve is
open in Inch mode when you push the Run/Inch palm buttons. Normally, in Inch the DSV
is open for only as long as the Run/Inch buttons are depressed. The Micro-inch setting
specifies the length of time the DSV is open regardless of how long the Run/Inch buttons
are held. Allowing finer adjustments than are possible in Inch, Micro-inch is designed to
facilitate setup on high-speed or short-stroke presses.
•
Connection of two Operator Stations directly to the WPC 2000. Additional Operator
Stations may be connected. Contact Wintriss Tech. Support for information.
•
WPC 2000 Main Processor board with diagnostic LEDs for troubleshooting.
SmartPAC 2 Options
SmartPAC 2 can be configured with the following options:
•
DiProPAC. When configured with the DiProPAC option, SmartPAC 2 can monitor up to
32 sensors, allowing detection of malfunctions such as stock buckling, misfeeds, and
improper part ejection.
•
ProCamPAC. The ProCamPAC option provides up to 16 programmable cam channels,
enabling SmartPAC 2 to control cam timing for feed, pilot release, air blow-off, lubricator,
and other press equipment. ProCamPAC also includes global cams for press operation
functions, DSV ON channel delay timing, and multiple on/off cycles for a single cam.
•
AutoSetPAC or WaveFormPAC. Provides two- or four-channel load monitoring,
protecting your press and dies from overloads and underloads. You can store high, low, and
repeatability setpoints with tool number, display, adjust, and recalculate setpoints, and
compare setpoints to the actual load. With WaveFormPAC, you can also display and save
load signatures and create up to four windows to monitor tonnage at points other than peak.
•
RamPAC. Provides automatic control of shut height and counterbalance and cushion
pressures by tool number.
•
ProPAC. Provides up to 16 analog, NPN, or PNP inputs that enable you to monitor in-die
dimensions and other process parameters.
•
Info Center. Enables die setup sheets and other plant-specific press information to be
displayed on the SmartPAC 2 screen. This option allows you to store information needed
throughout the plant on a central server, where it is available to operators via SmartPAC 2’s
Ethernet connectivity. In order to make use of Info Center functionality, SmartView (see
Appendix E) must be installed. Documentation of the Info Center option is available at
www.smartpac2.com/SmartView/InfoCenterSetupHelp.htm
•
SBR (SmartPAC Backup and Restore). Allows you to back up programmed tool settings to
a Windows laptop PC.
•
USB Disk Backup. Allows you to back up tool settings to a USB disk.