Wintriss SmartPAC 2, User Manual

Page: 150 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
2-106 Installation
Continuous Mode Test without Light Curtain(s)
This test verifies that your press operates correctly in Continuous mode. To verify
Continuous mode operation on a press with light curtains, return to the previous test (see
page 2-103). If your press does not run in Continuous mode, go to the next applicable test.
To run the Continuous mode test without light curtain, do the following, referring to
Figure 2-41 for LED locations and
Input Status
, page 4-44 for instructions in how to access
the Input Status screens:
1.
On the SmartPAC 2 front panel:
•
Make sure the Program/Run key switch is set to RUN.
•
Turn the Stroke Select key switch of OFF.
•
Select TWO HAND on the Mode Select Menu (see page 6-40)
•
Turn the Stroke Select key switch to CONT.
Verify that the “CONT SEL” item on the WPC Buttons and Switches Input Status screen
is ON (see Figure 4-26, page 4-45).
2.
Press the Prior Act button on the Operator Station. The Prior Act lamp should illuminate,
then turn off after eight seconds.
•
If the Prior Act lamp turns off after eight seconds, go to the next step.
•
If the Prior Act lamp does not turn off after eight seconds, stop! Do not go any further!
Call Wintriss Tech. Support.
3.
Press the Prior Act button and, before the indicator lamp goes out, press both Run/Inch
palm buttons, releasing them after bottom dead center on the first stroke. The press should
continue running.
•
If the press continues to run, go to the next step.
•
If the press stops, check the wiring of the palm buttons, and correct any problems. Run
the test again. If the press still stops, call Wintriss Tech. Support.
IMPROPER SAFEGUARDING
• Install safeguarding devices as needed to ensure operator safety. Follow the machine guarding
requirements of OSHA regulation 1910.217 and any other regulations and standards that apply.
• Ensure that guarding is properly installed to prevent access to the machine over, under or
around any guarding device.
Failure to comply with these instructions will result in death or serious injury.
INJURY DURING TESTING
• Keep all personnel away from the press during testing.
• Be sure there is no die or other tooling in the press during testing.
Failure to comply with these instructions will result in death or serious injury.
DANGER
!
DANGER
!