Wintriss Shadow VI, User Manual

Page: 73 / 159

Shadow VI User Manual 1107200
Installation and Checkout Chapter 2 page 61
J12 Setting
These instructions explain how to set Shadow for a second set of light curtains. The factory
setting is "1 SET". If you are installing a second set of heads, follow these steps.
1. Locate jumper location J12 in the control (refer to Figure 2-14 for location of
components). It is situated just above terminal block TB2 on the lower right-hand side of
the board. Notice that the jumper is set on pins 2 and 3 for "1 SET."
2. Move the jumper so that it will be on pins 1 and 2 for "2 SET."
"1 SET" setting
(Jumpers on bottom 2 pins)
J12
J12
"2 SET" setting
(Jumpers on top 2 pins)
** notice that
there are 2
jumpers side
by side at J12
Figure 2-24. Jumper Position for "1 SET" and "2 SET"
3. You will also have to perform some diagnostics to verify this setting. To do this, refer to
the section, "Aligning and tightening down Shadow VI components."
Plug in Connector and Replace Cover
Now that you have completed the wiring of the control and made the proper switch settings,
make sure all connections are properly plugged into position and that all conduits are in
place. Close the cover and tighten the locking screw on the control. Leave the transmitter
and receiver loose.
Connect 115 VAC wires from the control to the 115 VAC source. Make sure power is off
before making connections.
Now go on to the next step—aligning and tightening down your Shadow VI heads.
Aligning and Tightening Down Shadow VI
Components
DANGER
!
HAZARDOUS EQUIPMENT OPERATING
Remove power from the press and other hazardous machinery while you are aligning the
light curtain transmitter and receiver.
Failure to comply with these instructions will result in death or serious injury.