Wintriss autoset 1500, User Manual

Page: 68 / 102

1137200 AutoSet User Manual
3-20 Calibration
Final Checkout
To perform final checkout, follow these steps:
1.
Install a test tool on your press.
2.
On Standard AutoSet load analyzers, set the “% TOL” indicator dial on the AutoSet
processor board to position 1 (i.e., 2%), referring to
Setting the Percent High Tolerance ,
page 4-5.
or
On AutoSet Plus units, set the “% REP” indicator dial on the AutoSet processor board to
position 1 (i.e., 1%), referring to
Setting the Percent Repeatability Tolerance (AutoSet Plus
Only) , page 4-6.
3.
Run a few parts. On standard AutoSets, the 2% high tolerance setting should generate a
high tonnage fault. On AutoSet Plus units, the 1% repeatability setting should generate a
repeatability fault.
4.
Check to make sure that the press top-stops, that the message “HI” (standard AutoSets) or
“rEP” (AutoSet Plus units) flashes in the Setpoints LED display(s) for the out-of-range
strain link(s), and that the tonnage values flash in the Load LED display(s) on the affected
channels.
5.
If AutoSet displays a message but the press does not top-stop, there is a problem in your
top-stop circuit. Recheck all wiring and trace the cause of the problem. Do not continue
with this procedure until the press top-stops when you trip the high tonnage (standard
AutoSet) or repeatability (AutoSet Plus) setpoint.
6.
If the press is working properly, clear the fault by pressing the RESET button briefly
(standard AutoSet) or turning the DISPLAY switch briefly to RESET (AutoSet Plus).
Your AutoSet is now ready for use. Refer to Chapter 4 to learn how to make the settings
AutoSet uses to calculate high tonnage and repeatability setpoints.
The Final Checkout needs to be performed after installation (see Chapter 2) and calibration
procedures have been completed and before you run the press. Final Checkout ensures that
AutoSet will stop the press properly during a tonnage fault.
NOTICE