![background image](http://html1.mh-extra.com/html/winnebago/vista-26p/vista-26p_operators-manual_987532046.webp)
SECTION 4 -
APPLIANCES AND SYSTEMS
4-8
Further Information
Read the operating and safety information
provided in the Water Heater Operation Manual
in your InfoCase.
MOTORAID WATER HEATER
–If Equipped
The motoraid uses heat from the chassis
engine cooling system to heat water in the water
heater while driving. Hoses are routed from the
engine to a heat exchanger surrounding the water
heater tank.
Under normal conditions, the entire contents
of the water heater can be heated in about two
hours or 100 miles of driving. This means you
can have hot water at the faucets immediately
upon arriving at a site.
The motoraid also increases the capacity of
the engine cooling system.
PRESSURE-TEMPERATURE
RELIEF VALVE
On occasion, water may be seen seeping from
the water heater pressure temperature relief
valve. This is no cause for repair or replacement
of the valve.
Normally there is an air gap at the top of the
water heater tank, which acts as a pressure buffer.
In time, however, heated water may expand and
fill this air gap, causing a slight increase in water
pressure. This may cause the P-T valve to “weep”
until the air gap is manually replaced.
To Replace the Air Gap:
1. Turn off the Water Heater switch and
incoming water supply (city water and/or
demand pump).
2. Open a faucet in the motor home to relieve
water pressure.
3. Pull the handle of the P-T valve straight out
and allow water to flow until it stops.
NOTICE
Any leak in the heat exchanger or its
supply or return lines could cause loss of
coolant and subsequent engine failure.
We recommend that you periodically
inspect these connecting lines and the
heater to insure that no leaks have
developed.
CAUTION
Hot water can escape from tank causing
injury. Operate this valve only when the
water heater and engine cooling system
are cold.
Water Heater Exterior Service Access