SECTION 4 -
APPLIANCES AND SYSTEMS
4-6
Water Pump Switch
When use of the self-contained water system
is desired, turn the “Water Pump” switch on. The
“Pump On” light will illuminate when the pump
switch is on and the system is operable. Water
will be available as soon as a faucet is opened.
Refer to “Water Pump” for additional
information on the water pump and initial start-
up.
NOTE: Some models may be equipped with a
Water Pump switch in the water service
center on the outside of the coach or
within the bathroom area for your
convenience.
POWER CONTROL SYSTEM
(PCS)
–If Equipped
The Power Control System (PCS) monitors
the electrical usage of the appliances and
equipment in the coach and allows you to use
certain high energy appliances, such as the
microwave or washer/dryer, without overloading
the shoreline circuit breaker to help prevent
nuisance tripping.
Further Information
Refer to the manufacturer’s user guide
provided in your InfoCase for important
information on how this system operates under
several conditions, whether 20-amp, 30-amp, and
50-amp connections, or generator service.
NOTE: In 50-amp service, the load meter is
blank. In all other conditions, the load
meter displays actual current load.
WATER HEATER – GAS
NOTE: Read the Water Heater Operating Guide
in your InfoCase for complete safety
warnings, operating instructions, and
maintenance information before
operating the water heater.
Be sure the water heater is filled with water
before starting either electric or propane
operation.
To fill the water heater, turn the Water Pump
switch on and open a hot water faucet anywhere
in the coach. When water begins to flow steadily
from the faucet, the water heater is full.
Propane Gas Operation
•
Press the Water Heater switch on the Systems
Monitor Panel.
PCS Display Panel
(Located near monitor panel)
-Typical View