![background image](http://html1.mh-extra.com/html/winnebago/intent/intent_manual_987491034.webp)
SECTION 3 -
DRIVING YOUR MOTORHOME
3-10
•
Press top edge of hood panel in with palms of
hands, while locking Hood Locks with the
provided Hood Lock Key (located on key
ring).
ENGINE ACCESS – INTERIOR
Front Engine Cover
(Located between cab seats)
NOTE: Take precautions to protect interior
furnishings when removing engine cover.
The underside of the engine cover could
contain deposits of oil and fuel or other
engine fluids and substances that could
damage fabrics and interior furnishings.
To Remove the Engine Cover
•
Insert the supplied motor cover allen wrench
(located in the InfoCase) into the hole on the
rear top edge of the engine cover.
•
Turn the motor cover allen wrench to the left
(counter-clockwise) to unlock.
•
Remove the screws at the lower front corners
on each side of the engine cover.
To Reinstall the Engine Cover
•
Position the front end of the cover first, then
lower the rear end.
It is important to ensure the front edge is
pushed completely forward to the radiator
cover to ensure an air-tight seal.
•
Press the rear end of the engine cover down
and turn the hex wrench to the right
(clockwise) until the latch pulls the cover
downard and stops.
•
Reinstall the screws at the lower front corners
on each side of the engine cover.
ENGINE COOLING SYSTEM
Do not remove the radiator cap while engine
and radiator are still hot. Always check coolant
level visually at the see-through coolant
reservoir.
NOTE: Your chassis engine cooling system is
filled with special extended-life coolant.
See the chassis manual for the correct
type of coolant. The coolant system
MUST be refilled or topped up with the
same type of coolant as equipped to
maintain the special long-life properties.
Further Information
Refer to the chassis manual in your InfoCase
for information and precautions on filling,
servicing, and checking the fluid level.
TIRES
Improper tire pressure can result in tire
overloading and abnormal wear and also affects
handling, ride characteristics, and fuel economy.
Motor Cover Allen Wrench
(Located in the InfoCase)
Insert Allen
Wrench
Remove
screws
NOTICE
When refilling the coolant system of a
vehicle equipped with a rear auxiliary
automotive heater and motoraid water
heater, be sure to allow for additional
coolant capacity of the heater and its
supply and return hoses.