SECTION 4
APPLIANCES & SYSTEMS
4-10
3. Furnace fan should start to blow immediately
after setting the thermostat.
4. After about 30 seconds, the furnace burner
should light.
5. The furnace should now cycle off and on
automatically as the thermostat demands just
like a household furnace.
NOTE:If heat does not come out of the heat
ducts after a minute or so the burner is
not lit.
Turn thermostat off for 3-5 minutes,
check to be sure propane gas tank valve
is open and tank is not empty, then try
steps 2-4 again.
If the furnace will not light after three
attempts, go to Shut Down steps and
contact your dealer or a local RV service
center for repair.
To Shut Down:
1. Move thermostat switch to OFF position.
2. Close propane tank valve if coach will be
stored for a period of time.
For Further Information
Please see the furnace operating instructions
provided in your InfoCase for further
information, including operating precautions,
and periodic maintenance. See the Coach
Maintenance Schedule for recommended
intervals.
NOTE: If the furnace burner has any residuals
of metal protectant or lubricants used
during manufacture of the furnace, it may
smoke slightly when the furnace is used
for the first time and may set off your
smoke alarm.
We recommend that you provide
adequate ventilation when using the
furnace for the first time to avoid a
nuisance smoke alarm.
We do not recommend removing the
smoke alarm battery.
ELECTRONIC THERMOSTAT
(Central Heat/Air Conditioning
System)
The thermostat, on the One Place panel,
controls heating, air conditioning, cooling fan
and heat pump operation.
NOTE:The thermostat does not automatically
switch between heating and cooling. You
must place the thermostat switch in the
desired position.
Thermostat/Switch
• Move from OFF to
desired temperature
for furnace operation
Room Temperature
Thermometer
Thermostat (Source) Switch
COOL= Air Conditioning
ELEC = Heat Pump
GAS = Furnace
Temperature Selector
Central Air Thermostat
