![background image](http://html1.mh-extra.com/html/winnebago/fuse-23a-2019/fuse-23a-2019_operators-manual_987483050.webp)
SECTION 6 –
ELECTRICAL
6-2
The power cord is designed to ground the
electrical system through the receptacle. It is also
designed to carry the amperage output of most
campground outlets. If the electrical receptacle to
be used is designed to mate with the prongs of the
power cord plug, the electrical connection can be
expected to carry rated load.
Power Cord Door
(Models with power cord compartment on
sidewall)
A flip-up passage in the power cord door lets
you route the power cord out of the compartment
and close the door while the power cord is
connected.
After disconnecting the power cord, neatly
replace it in the cord compartment.
Park Fuses or Breakers
Most campgrounds are equipped with a fuse
or circuit breaker at the receptacle (which we
recommend shutting off before engaging or
disengaging the power cord.) This protects the
park’s wiring, as well as the power cord on your
vehicle from electrical damage. If electrical
power fails, contact the park attendants and have
them check the fuse or breaker for your supply
receptacle.
INVERTER UNIT – 1000W
The inverter changes 12-volt DC battery
power into 120-volt AC power for use by 120-
volt AC equipment inside the motorhome. The
inverter unit is located inside an interior cabinet.
NOTE: Batteries will deplete with use of the
inverter.
Monitor battery levels regularly when
not connected to shoreline or generator
power.
WARNING
This connection is for 110/125 Volt AC,
60 Hz 30 Ampere supply.
Do not exceed circuit rating. Exceeding
the circuit rating may cause a fire and
result in death or serious injury.
30 Amp Receptacle
•
Swivel the small cover section upward
to access the cord passage.
WARNING
Service inlet access must be closed when
utility connections are not in use.
•
Route power cord through passage
and close door while shoreline is
connected to outlet.