![background image](http://html1.mh-extra.com/html/winnebago/fuse-23a-2019/fuse-23a-2019_operators-manual_987483027.webp)
3-3
SECTION 3 –
DRIVING YOUR MOTORHOME
system which is not properly secured. Children
are always safer in the rear seats (behind the cab
area).
A child restraint system is designed to be
secured in a vehicle seat by a lap belt or the lap
belt portion of a lap-shoulder belt.
When purchasing a child restraint system,
follow these guidelines:
1. Look for the label certifying that it meets all
applicable safety standards.
2. Make sure that it will attach to your vehicle
and restrain your child securely and
conveniently so that you are able to install it
correctly each time it is used.
3. Be certain that it is appropriate for the child's
height, weight, and development. The
instructions and/or the regulation label
attached to the restraint typically provides this
information.
4. Review the instructions for installation and
use of the restraint. Be sure that you
understand them fully and can install the
restraint properly and safely in your vehicle.
Tether Anchor Loop
–
If Equipped
If your motorhome has a dinette, it may be
equipped with a child seat tether anchor loop
located on the floor or wall directly behind the
forward facing dinette seat.
NOTE: The dinette table must be in the lowered
position when a child seat is in use.
Further Information
See the child seat manufacturer’s specific
instructions for proper attachment and
adjustment of the tether and seat belts.
KEYS
Your motorhome is supplied with several
keys. In addition to the chassis manufacturer’s
ignition key, you receive keys for the entrance
door and exterior compartment doors.
Keys have an identification number, either a
small metal tag or stamped into the key head.
These numbers are recorded on the vehicle’s
component model/serial sheet, which is included
in your InfoCase. In case keys are lost or stolen,
your dealer or a locksmith can provide you with
duplicate keys or modify the locks.
MIRRORS – POWER EXTERIOR
Always adjust mirrors for maximum rear
visibility before traveling. Make sure the seat is
adjusted for proper vehicle control and that you
are sitting back squarely into the seat.
Tether Anchor Loop
1. Lower the dinette table.
2. Route the tether over the top of the dinette
seat back and hook it to the anchor loop on
the floor.
3. Fasten the lap belt.
-Typical View,
(Your motorhome may differ in appearance)
3
2
1