![background image](http://html1.mh-extra.com/html/winnebago/forza-34t/forza-34t_manual_987481029.webp)
3-3
SECTION 3 –
DRIVING YOUR MOTORHOME
+Lounger
(Co-Pilot Seat)
–
If Equipped
Your motorhome may be equipped with a
+Lounger, which is featured with an extendable
footrest (see previous operation instructions),
and a convenient built-in workstation. This flip-
up hard surface tablet feature stores on the
outboard side of the seat when not in use.
To Use Tablet
•
Extend tablet all the way out (toward front of
the motorhome).
•
Lift tablet up and rotate directly toward you
(as you are sitting in the passenger seat).
•
Once tablet is completely raised, lay down
over lap. Tablet is now ready for use.
Reverse steps to lower tablet back into stored
position.
SEAT BELTS
Seats intended for occupancy while the
vehicle is in motion are equipped with seat belts
for the protection of the driver and passengers.
Lap Belts
The lap belts must be worn as low as possible
and fit snugly across the hip area. Always sit
erect and well back into the seat. To gain full
protection of the safety belt, never let more than
one person use the same safety belt at any one
time, and do not let the safety belts become
damaged by pinching them in the doors or in the
seat mechanism. After any serious accident, any
seat belts which were in use at the time must be
inspected and replaced if necessary.
Adjustment
To lengthen belt, swivel the tab end at a right
angle to belt and pull strap to desired length. To
shorten, pull loose end of belt.
To Fasten
Be sure belt is not twisted. Grasp each part of
the belt assembly and push tongue into buckle.
Adjust to a snug fit by pulling the loose end away
from the tongue.
To Release
Press button in center of buckle and slide
tongue out of buckle.
Co-Pilot Footrest Lever
(Located on inboard
side of co-pilot seat)
-Typical View
WARNING
Snug and low belt positions are essential.
This will ensure that the force exerted by
the lap belt in a collision is spread over the
strong hip area and not across the
abdomen, which could result in serious
injury.
Only seats equipped with seat belts are to
be occupied while vehicle is in motion.
Swivel seats must be in the locked,
forward facing position while vehicle is in
motion.
1- Insert tab into buckle
slot until it “clicks” and is
locked
2- Pull strap to tighten
3- Press to
release