3-13
SECTION 3 -
DRIVING YOUR MOTORHOME
•
Remove the screws at the lower front corners
on each side of the engine cover.
To Reinstall the Engine Cover
•
Position the front end of the cover first, then
lower the rear end.
It is important to ensure the front edge is
pushed completely forward to the radiator
cover to ensure an air-tight seal.
•
Press the rear end of the engine cover down
and turn the hex wrench to the right
(clockwise) until the latch pulls the cover
downard and stops.
•
Reinstall the screws at the lower front corners
on each side of the engine cover.
ENGINE COOLING SYSTEM
Do not remove the radiator cap while engine
and radiator are still hot. Always check coolant
level visually at the see-through coolant
reservoir.
NOTE: Your chassis engine cooling system is
filled with special extended-life coolant
that is not the same as common anti-
freeze available at retail outlets.
The coolant system MUST be refilled or
topped up with the same type of coolant
as equipped to maintain the special long-
life properties.
Further Information
Refer to the chassis manual in your InfoCase
for information and precautions on filling,
servicing, and checking the fluid level.
CHASSIS BATTERY
DISCONNECT SWITCH
The Chassis Battery Disconnect switch
disconnects most chassis electrical loads from
the chassis (starting) batteries to avoid discharge
by constant draws such as engine computers,
radio clock, sensors, etc. (except the electric
entrance step). This feature is intended to help
conserve battery charge during storage.
NOTE: The Chassis Battery Disconnect switch
must be ON to start the engine.
Motor Cover Allen Wrench
(Located in the InfoCase)
Insert Allen
Wrench
NOTICE
When refilling the coolant system of a
vehicle equipped with a rear auxiliary
automotive heater and motoraid water
heater, be sure to allow for additional
coolant capacity of the heater and its
supply and return hoses.
Chassis Battery Disconnect Switch
(Located near entrance door)
-Typical View
