3-5
SECTION 3 –
DRIVING YOUR MOTOR HOME
Basic Operating Instructions
Sideview Cameras
–If Equipped
The optional sideview cameras allow you to
see what is beside you before turning or changing
lanes.
The sideview cameras activate with the
corresponding turn signals and replace the rear
camera view on the monitor until the turn is
completed or the signal lever is canceled
manually.
Further Information
See the rearview monitor manufacturer’s
complete operating information in your
InfoCase.
12-VOLT FRONT DROP-DOWN
SOLAR/NIGHT SHADE
–If Equipped
Your coach may be equipped with a 12V
Front Drop-Down Solar/Night Shade that
provides privacy and solar heat protection as well
as a sunvisor feature.
The power switches for the 12V Front Drop-
Down Solar/Night Shade are located on the dash.
Press the Solar Shade (black) or the Night
Shade (white) switch up or down to adjust the
shade to the setting that best suits your needs.
Dual range motors provide lowering of either
two shades to visor height restriction when the
ignition is ON and lowers completely to cover the
entire windshield when the ignition is OFF.
The Chassis Battery Disconnect switch must
be ON to supply power to the solar/night shade.
NOTE: If power is gradually drained and falls
below the lower limit of 11-volts, the
motors could lose their electronic Set
Limits and will require reprogramming
once normal power has been restored.
Power
• Turn ON to activate monitor for rear viewing
while driving or parked. Key must be on.
• In OFF (Standby) position the monitor is
“asleep” and will “wake up” when the
transmission is shifted into reverse.
Menu
• Each one press less than 1 second enters
brightness, contrast, color, or tint adjust mode.
(Time out of menu is approximately 5 seconds from
last key pressed.)
• Press menu button over 2 seconds to enter
setup menu.
(Press again before time out exits menu mode.)
Select
• Pressing the “Select” button sequences source
input modes from Ch1, to Ch2, to Ch3.
Up/Down
• Pressing UP increases brightness, contrast,
color, or tint level.
• Pressing DN decreases brightness, contrast,
color, or tint level.
Day/Night
• Pressing DAY/NIGHT button sequences day/
night backlight compensation through DAY,
NIGHT, and AUTO modes.
/-
• Pressing “+” button increases speaker volume.
• Pressing “-” decreases speaker volume.
12-Volt Front Drop-Down Solar/
Night Shade Switches
(Located on dash)
-Typical View