![background image](http://html1.mh-extra.com/html/winnebago/2010-meridian-v-class/2010-meridian-v-class_operators-manual_987447101.webp)
8-5
SECTION 8 –
ENTERTAINMENT
Video Programming from the Video
Selection Box
-If Equipped
•
Turn On video
selection box and
select desired input
(Satellite, DVD, or
Aux) for TV2.
•
Turn On TV and press the SOURCE or
INPUT button on the TV or TV remote to
select INPUT1 or AV1.
Play TV Through Stereo Speakers
The exterior entertainment center TV is
connected to the video selection box, the rooftop
antenna, and the park cable input. To play this
signal through the stereo speakers:
•
Tune TV to desired channel or input.
•
Turn On the radio and press the MODE button
on the remote or the radio until it displays AV-
IN1.
•
Adjust the volume on the TV or the radio for
desired level.
Further Information
For further information and operating
instructions, see the manufacturer’s information
included in your InfoCase.
FLIP-DOWN SCREEN VIDEO
PLAYERS
(Rear Bunk models only)
–If Equipped
The flip-down LCD screen DVD Video
Players are mounted overhead in each of the bunk
beds.
The Video Players operate independently so
the occupant of one bunk may watch a DVD
while the other watches a different DVD. The
same DVD can be watched on both players at the
same time as well. The top player is the master
unit. Place the DVD in the top player and begin
playing the DVD. Select AV1 input on the unit in
the lower bunk to view the DVD playing in the
upper bunk.
The players each contain auxiliary audio-
video inputs for connection of a video game
system or other audio-video equipment if
desired.
Remote Control and Wireless
Sound
•
A sensor array
above the
screen of each
Video Player
receives command signals from the remote
control.
•
The sensor array also continuously transmits
wireless sound signals for reception on IR
wireless headphones.
•
See Video Player instruction guide in your
InfoCase for remote control instructions and
additional information on wireless
headphones.
12-Volt Master Power
•
The Video Players operate on
12-volt DC current. Turn on the
12-volt master power (TV)
switch shown, located on the
backwall of the top bunk.
NOTE: To avoid drain on the 12-volt house
battery, we recommend turning the
master power switch off when Video
Players will not be in use.
Video Player Power ON/OFF
•
Press the POWER button on either
the remote control or the unit once
to turn the power on. Press the
same button to turn the player off.
POWER
AV
MENU
POWER