3-3
SECTION 3 –
DRIVING YOUR MOTOR HOME
3. Be certain that it is appropriate for the child's
height, weight, and development. The
instructions and/or the regulation label
attached to the restraint typically provides this
information.
4. Review the instructions for installation and
use of the restraint. Be sure that you
understand them fully and can install the
restraint properly and safely in your vehicle.
Tether Anchor Loop
-If Equipped
If your coach has a dinette, it may be equipped
with a child seat tether anchor loop located on the
floor directly behind the forward facing dinette
seat.
NOTE: The dinette table must be in the lowered
position when a child seat is in use.
Further Information
See the child seat manufacturer’s specific
instructions for proper attachment and
adjustment of the tether and seat belts.
KEYS
Your motor home is supplied with several
keys. In addition to the chassis manufacturer’s
ignition key, you receive keys for the entrance
door and exterior compartment doors.
Keys have an identification number, either a
small metal tag or stamped into the key head.
These numbers are recorded on the vehicle’s
component model/serial sheet, which is included
in your InfoCase. In case keys are lost or stolen,
your dealer or a locksmith can provide you with
duplicate keys or modify the locks.
HAZARD WARNING FLASHERS
The hazard warning flashers provide
additional safety when the vehicle must be
stopped on the side of the roadway and presents a
possible hazard to other motorists. When the
flashers are on, it serves as a warning to other
drivers.
Further Information
See your chassis manual for instructions on
activating, operating, and canceling hazard
warning flashers.
MIRRORS – POWER SIDEVIEW
EXTERIOR
–If Equipped
Always adjust mirrors for maximum rear
visibility before driving off. Make sure the seat is
adjusted for proper vehicle control and that you
are sitting back squarely into the seat.
The mirrors may also contain heating
elements to de-fog or de-ice the mirror glass
during cold weather operation. An ON-OFF
switch for the mirror heaters is located near the
remote mirror controls.
The ignition switch must be on to operate
mirror controls and heaters.
Tether Anchor Loop
1. Lower the dinette table.
2. Route the tether over the top of the dinette seat
back and hook it to the anchor loop on the floor.
3. Fasten the lap belt.
3
2
1
