12-15
SECTION 12 –
MISCELLANEOUS
During windy conditions, the Direct Response
System detects awning motion. (The motion
sensor is located in the awning rail.) The system
operates by gauging the vertical motion of the
awning’s leading edge. When continuous motion
exceeds the factory preset threshold for two
seconds or longer, the awning will retract
automatically. The control panel provides four
factory preset threshold values. You may want to
experiment to find the best setting that suits your
needs.
•
LOW - The lower the selection of threshold,
less motion is required before the system
closes automatically.
•
HIGH - The higher the selection of threshold,
more motion is required before the system
closes automatically.
Wind gust detection is incorporated into the
awning software. When the motion value is
suddenly and sharply increased above a safe
maximum value, then the two second persistence
measure is overridden and the awning will
immediately close.
Further Information
For complete operating instructions, refer to
the manufacturer’s information provided in your
InfoCase.
POWER AWNING (OVER THE
DOOR)
–If Equipped
To Open the Awning
Press and hold the Door Awning Switch
“Out” until the awning is in the desired position,
then release.
To Close the Awning
Press and hold the Door Awning Switch “In”
until the awning is in the stored position, then
release.
NOTE: As a safety feature, the awning will not
extend if the ignition key is on.
Further Information
For complete operating instructions, refer to
the manufacturer’s information provided in your
InfoCase.
Over the Door Awning Switch - Typical View
(Located near the entrance door)
