![background image](http://html1.mh-extra.com/html/winnebago/2009-adventurer/2009-adventurer_operators-manual_987444118.webp)
SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
10-8
Also, freezing rain and snow can prevent the
slideout cover-awning (if equipped) from closing
and may cause damage to the cover-awning,
slideout room, weather seals, and mechanisms.
To avoid potential damage, we recommend
retracting your slideout room during extreme
weather conditions.
SLIDEOUT ROOM
TROUBLESHOOTING –
ELECTRIC
Battery Voltage or Circuit Breaker
Problems
If the slideout room will not work:
•
Turn the Chassis Battery Disconnect Switch
OFF and then ON again. This will (in many
cases) reconnect power to the slideout system.
•
Τ
he chassis battery may be low on charge.
Press and hold the Battery Boost Switch on
the dash while pressing the slideout control
switch. This momentarily connects the house
batteries to assist in slideout room operation.
•
The circuit breaker may be tripped. The
circuit breaker, labeled “Slideout Power” is
located on a panel on an interior wall of the
passenger side storage compartment just
behind or ahead of the entrance door.
Problems Retracting the Room
Set the Park Brake if the red Park Brake light
flashes while pressing the Retract (IN) button.
If an error is detected on your slide system, the
green LED on the left side of the control panel
will blink an error code. If an error code appears,
see the manufacturer’s user guide included in
your InfoCase to determine the problem. The
error code must be cleared prior to operating the
room. To clear the error, press the Service Button
with a small tool such as a ballpoint pen,
toothpick, etc. Before operating the room after an
error has been detected, check for obvious faults
such as obstructions prior to trying to operate the
room again. If the error code appears again, the
room will need to be retracted using either the
manual retraction method or the fully manual
method. Both methods listed below are intended
as a means to retract the room to prepare the
coach for travel to the nearest authorized service
center.
Manual Mode
Manual Mode lets you individually move the
two room arms by pressing the IN and OUT
buttons on the control pad.
This mode can be used
only if there is not a motor failure or full
electrical system failure.
To override the encoder
and enter the Manual Mode, press and hold the
Service Button until the two LEDs begin to flash.
Green light will flash error code
if system malfunctions*
Service “Reset”
Button*
Red light will flash if
park brake not set
*Not equipped on single mechanism systems
Slideout Touchpad
(Located near monitor panel)
-Typical View