7-3
SECTION 7 –
PLUMBING
2. Turn water pump switch to “OFF” position.
3. Fill water tank.
4. Open all faucets, hot and cold.
5. Turn on pump switch.
6. Close each faucet as it begins to deliver a
steady stream of water (close cold water first).
Leave hot water faucets on until they also
deliver a steady stream of water. This will
ensure that the water heater is filled with
water.
7. Check to be sure pump stops soon after all
faucets have been closed.
8. Pump is now ready for automatic operation.
Pump will start when a faucet is opened and
stop when the faucet is closed.
COLD WATER FILTER
–If Equipped
Open the galley sink cold water faucet only to
obtain filtered cold water for drinking or cooking.
The galley faucet cold waterline flows
through an activated carbon filter that removes
chlorine and odors for taste-free drinking water.
Replacing the Cold Water Filter
Cartridge
You should replace the filter cartrige every
season and when water flow from the faucet is
too slow for convenience. The cartridge MUST
be replaced at least every 12 months.
•
Place a container beneath the filter to catch
any water remaining in the waterlines during
filter removal.
•
Twist the filter cartridge counter-clockwise
(to the left) about one-quarter turn, then pull it
down and out of the filter socket.
•
Insert a new water filter cartridge up into the
filter socket as far as possible and twist it
clockwise (to the right) one-quarter turn until
it stops.
•
Purge a new filter cartridge before using for
drinking. Run a few gallons of water through
the filter and discard the water (or use for
watering plants) to avoid ingesting carbon
dust or particles that may have been present in
the new filter cartridge.
Diverter Plug
•
The temporary diverter plug is provided to
prevent water flow from the filter base in
situations when the waterline must be used
with the filter removed, such as winterization
or lack of spare filter cartridge.
•
Diverter plug is installed in the same manner
as the filter.
Cold Water Filter Assembly below Galley Sink
(
Hot waterline is not filtered
)
Insert new filter up into filter socket –
Press and twist 1/4-turn clockwise
(to the right).
