4-5
SECTION 4 –
APPLIANCES AND SYSTEMS
NOTE: Some models may also have a pump
switch in the water system compartment
on the outside of the coach.
WATER HEATER – GAS
-If Equipped
NOTE: Read the Water Heater Operating Guide
in your InfoCase for complete safety
warnings, operating instructions, and
maintenance information before
operating the water heater.
Be sure the water heater is filled with water
before starting either electric or propane
operation.
To fill the water heater, turn the Water Pump
switch on and open a hot water faucet anywhere
in the coach. When water begins to flow steadily
from the faucet, the water heater is full.
Propane Gas Operation
•
Press the Water Heater switch on the Systems
Monitor Panel.
•
The “Pilot Out” light will glow for about 10-
15 seconds, then it will go out. The “Heater
On” indicator will remain lit.
•
If the “Pilot Out” light comes on during
propane operation, it means that the burner
has gone into “lockout” mode and must be
restarted. If this happens, turn the Water
Heater switch off for about 5 minutes, then
turn it back on.
WATER HEATER - GAS/
ELECTRIC
–If Equipped
(with Motoraid water heating system)
The gas/electric water heater has a dual power
feature. It can operate from propane gas or 120-
volt house current; or it can use both at the same
time for quicker recovery at times when you are
using a lot of hot water.
Read the Water Heater Operation Manual for
complete Safety Warnings, Operating
Instructions, and Maintenance Information
before operating the water heater.
Be sure the water heater is filled with water
before starting either electric or propane gas
operation.
To fill the water heater, turn the
Water Pump switch on and open a hot water
faucet anywhere in the coach. When water begins
to flow steadily from the faucet, the water heater
is full.
For Propane Gas Operation
Press the Water Heater switch on the Monitor
Panel. The “Pilot Out” light will glow for about
10-15 seconds, then it will go out. The “Heater
On” indicator will remain lit. If the “Pilot Out”
light comes on during gas operation, it means that
the burner has gone into “lockout” mode and
must be restarted. If this happens, turn the Water
Heater switch off for about 5 minutes, then turn it
back on.
See the water heater user guide in your
InfoCase for further information.