2.1 Wiring Requirements
The following common safety precautions should be observed before installing any electronic
device:
•
Strive to use separate, non-intersecting paths to route power and networking wires. If
power wiring and device wiring paths must cross make sure the wires are perpendicular
at the intersection point.
•
Keep the wires separated according to interface. The rule of thumb is that wiring that
shares similar electrical characteristics may be bundled together.
•
Do not bundle input wiring with output wiring. Keep them separate.
•
When necessary, it is strongly advised that you label wiring to all devices in the system.
•
Do not run signal or communication wiring and power wiring in the same conduit. To
avoid interference, wires with different signal characteristics (i.e., different interfaces)
should be routed separately.
•
Be sure to disconnect the power cord before installing and/or wiring your device.
•
Verify the maximum possible current for each wire gauge, especially for the power
cords. Observe all electrical codes dictating the maximum current allowable for each
wire gauge.
•
If the current goes above the maximum ratings, the wiring could overheat, causing
serious damage to your equipment.
Be careful when handling the unit. When the unit is plugged in, the internal components
generate a lot of heat which may leave the outer casing too hot to touch.
2.2 Mounting Guide
The 32” PT Series 4K UHD LCD Monitor can be applied for several different installation
methods, including wall mount, VESA mount. Refer to sub-sections below for more details.
Caution
Follow mounting instructions and use recommended mounting
hardware to avoid the risk of injury.
Attention
Suivez les instructions de montage et d'utilisation recommandé le
matériel de montage pour éviter le risque de blessure.
The 32” PT Series 4K UHD LCD Monitor comes with VESA Mount holes for mounting.
Winmate provides VESA mounting kit by request.
VESE plate dimensions and screw size:
Size
VESA PlateSize
Screw Size
32”
100x200 mm, 200x200 mm
M4x25, Ø6 mm
Mount the wall bracket to the wall using fasteners appropriate for the type of wall structure
following all applicable building code standards. Ensure the unit is mounted to a solid structure
material and surface, such as a support beam or wall.
Under normal use, the I/O port is always at the bottom of LCD Monitor.
