MOUNT ASSEMBLY
6) Find the end of the mounting pipe with
holes on the sides for screws. Insert
this end into the middle of the foot as
shown.
7) Insert the 2 1/2" bolt through the
foot and pipe as shown. Screw a large
flange nut onto the end of the bolt to
hold the pipe and foot together.
Don’t
tighten the nut completely yet!
Figure 5.
8) Find the square holes on either side of
the bottom of the pipe. Raise the pipe
slightly and insert a 5/8" bolt through
these holes and out the side of the
foot. Install the large flange nuts on
the outside of the foot on the 5/8" bolts
to hold the pipe in place.
Don’t tighten
the nuts completely!
9) Secure the foot to it’s permanent
location. Adjust the end of the pipe
so it is perpendicular to the ground.
Tighten the hex nuts to hold the pipe
in place.
ATTACHING ANTENNA TO MAST
10) Loosen U-bolt nuts. Slide U-bolt over
mast. Point small end of antenna
toward stations and tighten securely.
ATTACHING THE COAX
Connect the 75 ohm coaxial cable to the
matching transformer. The connection
should be finger tight.
The coaxial
downlead may be secured to the mast
with tape or plastic wire ties.
ANTENNA ASSEMBLY
1) Remove antenna and hardware
bag from carton. Unfold the
tetrapoles and the shorter VHF
elements on underside of the boom.
Make sure they lock into place. See
Figure 1.
2) Insert the U-bolt into the mast clamp
insert and then into the mast clamp
on the antenna. Loosely thread 2
large flange nuts onto the U-bolt. See
Figure 2.
DO NOT TIGHTEN THE FLANGE
NUTS AT THIS POINT.
3) Install the matching transformer
using two small flange nuts and four
washers from the hardware bag.
Make sure to place the leads between
two washers on each post. Tighten the
small flange nuts to secure the leads.
See Figure 3.
4) Flip the antenna over and unfold all of
the long VHF elements until they lock
into place. Be sure the elements are
locked into position and are flat and
parallel to each other. Unfold the
UHF elements.
5) Insert the plastic end caps. Use a
rubber mallet to gently tap them into
the antenna booms to secure them.
Figure 2
Large
Flange
Nuts
U-Bolt
Mast Clamp Insert
Mast Clamp
Figure 5
Figure 1
Tetrapoles
VHF Elements
UHF
Elements
Mast Clamp
Matching
Transformer
Location
VHF Elements
Connecting the matching transformer.
Figure 3
Tetrapole
Leads
Post for Lead
Post for Lead
Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other countries. App Store is a service mark
of Apple Inc., registered in the U.S. and other countries. Google Play and the Google Play logo are trademarks of Google LLC.
Winegard is a registered trademark of Winegard Company. Disclaimer: Although every effort has been made to ensure that the
information in this manual is correct and complete, no company shall be held liable for any errors or omissions in this manual.
Information provided in this manual was accurate at time of printing. If the antenna does not function as expected, please contact
Winegard Co.
