Figure 4
Figure 2
U.S. Pat. No. D355,887,
D358,365, 5,515,240 Power
supply housing design.
CAUTION: No splitters or coupler should be installed in the coax
line between the antenna and power supply.
Attach
coax here.
NOTICE: FAILURE TO PROPERLELY CONNECT
CABLES MAY RESULT IN DAMGE TO TV SET.
TO PREAMP
TO TV
Figure 3
3-1/4"
#6x1/2
Screws
(2) E-Clip
(2) Pin
(2) Hex Nut
Mast Bracket
U-Bolt
Mast Clamp
Figure 1
WARNING:
INSTALLATION OF ANTENNAS NEAR POWER LINES IS DANGEROUS.
FOR YOUR SAFETY, FOLLOW THE INSTALLATION INSTRUCTIONS.
INSTALLATION
This SENSAR antenna may be installed inside or outside on any mast or
pole.
DO NOT MOUNT OVER CHIMNEY OPENING.
STEP 1.
Make sure "W" opening is on bottom side of antenna head, foot
embossing points down. Slide metal mounting bracket up into back bracket
on antenna and attach with pins and E-clips. See Figure 1.
STEP 2.
Insert "U" bolt thru mast clamp and mast bracket and start hex
nuts onto "U" bolt. See Figure 1.
STEP 3.
Slide mast thru "U" bolt and tighten hex nuts with 7/16" wrench.
Model GS-1100, VM-1100 (Non-amplified Models ONLY)
Attaching Downlead Cable
STEP 1.
Attach downlead cable to F-jack on back of antenna head and
tighten securely. (Figure 4). Tape downlead to mast and run cable to TV.
STEP 2.
Attach "F" connector to downlead and connect to "F" jack on TV.
Models GS-2200, VM-2200
(Amplified Models ONLY)
Attaching Downlead Cable
STEP 1.
Attach downlead cable to F-
jack on back of antenna head and
tighten securely. (Figure 4) Tape
downlead to mast and run cable to
power supply location.
STEP 2.
Attach "F" connector to
downlead and connect to "F" jack on
power supply marked "TO PREAMP".
See Figure 2.
STEP 3.
Attach "F" connector to cable
from TV and connect to "F" jack on
power supply marked "TO TV". See
Figure 2.
STEP 4.
Mount the two #6 screws
vertically 3-1/4" apart leaving screw
heads approximately 1/8" from wall.
See Figure 3.
STEP 5.
Hang power supply onto
screws and plug power supply AC
power cord into receptacle.
