background image

Installing the Mounting Feet

1.  If the handle has been installed on the antenna, remove the 

screws holding the handle to the antenna with a Phillips 
screwdriver, and remove the handle.

2.  Pull off the rubber foot pads from the bottom of the four 

antenna feet.

3.  Insert the threaded post up through the hole of each 

attached foot, and with a Phillips screwdriver, tighten a 
screw into each. 

Installing the Antenna

1.  Do not attempt to install the antenna in the rain or under 

any wet conditions. Install in dry conditions only.

2.  For best performance and to reduce signal acquisition 

time, park the vehicle on a level surface that is free of 
obstructions such as trees or large buildings. Make sure  
you have a clear view of the southern sky.

3.  Select a level spot on your roof for installation. Level the 

base front-to-back and side-to-side. If the base is not 
level, the antenna may require more time to locate the 
correct satellite or may not locate the correct satellite.

4.  Ensure proper distance to other rooftop equipment 

is maintained. Be sure no roof-mounted equipment 
is blocking the satellite “line of sight”; see clearance 
requirements below.

Mounting foot (4)

with Screw (4)

Cable entry plate

Cable tie (2)

Mounting 

screw (20)

Remove the four 
rubber foot pads

Remove Handle

Threaded Post

Screw

Attached 

Foot

Mounting Foot

18.8 in

.

24.9 in.

31.1 in.

15 in

.

40.3 in.

8 in.

12 in.

10 in.

Obstruction Height

Minimum Distance to be Maintained from Antenna

Signal Obstruction Chart

Roof Mount Kit RK-4000

 

For a complete list of compatible antennas, visit 

www.winegard.com/mounts

For help, email [email protected] 

or call 1-800-788-4417

2452390

Rev0 5-17

Reviews: