Winegard Company
3000 Kirkwood St., Burlington, IA 52601-2000
Printed in U.S.A. © Winegard Company 1998
WINEGARD
Pipe Mount Kit
Model DS-3000
WARNING
INSTALLATION OF ANTENNAS NEAR POWER LINES IS DANGEROUS.
FOR YOUR SAFETY, FOLLOW THE INSTALLATION INSTRUCTIONS.
INSTRUCTIONS
NOTE: This mount is designed to fit on the
side of a house. Either end of the mast can be
attached to the base, depending on how much
clearance is required for the antenna.
NOTE: Lag bolts not supplied.
NOTE: Not recommended for antennas with a
boom length longer than 40".
STEP 1.
Locate a stud in the area to be installed.
STEP 2.
Drill a small pilot hole, to help start
threading the lag bolts (5/16 x 3" recommended).
STEP 3.
Apply silicone sealant to back of the
base to seal holes.
STEP 4.
Using lag bolts tighten the base to the
wall. Make sure mast is plumb.
®
Do not overtighten.
You can deform the mast.
Tighten securely when
mast is plumb.
Stud
Lag Holes (5/16 x 3" lag
screw recommended)
Make sure mast is plumb.
If siding is heavy enough
these holes can also be
used to help secure the
base.
