1.
Press and hold the
Light (1) & Set
(5)
buttons simultaneously for 15
seconds until you hear a beep. Then release the buttons.
2.
Press the
Light
(1)
button (only) to select the zone. The zone will show
in the left display window
(3)
and the temperature will show in the right
display window
(7).
a.
P01: the lowest temperature of upper zone
b.
P02: the highest temperature of upper zone
c.
P03: the lowest temperature of lower zone
d.
P04: the highest temperature of lower zone
3.
Use the
+
(2)
and
–
(4)
buttons to adjust the temperature
4.
Repeat the steps in #2 and #3 for each setting you want to change
5.
The operating panel will automatically exit programming mode after being
idle for 10 seconds.
Replacing the Charcoal Filter
Located on the back wall of your wine cellar, Turn
counterclockwise to unlock, then remove. Replace with a
new filter, turn clockwise to lock in place. Reorder part #:
264 08 44 at www.WineEnthusiast.com
Interior Light
• To complement the look of your wine collection, a soft light
has been built
into the wine and beverage cooler. Simply push the "Light" button and the
light comes on, push again for off. For maximum energy efficiency, leave
light off when not viewing your collection.
