6
Upright Vacuum
Call: 1-800-USA-CLEAN (800-872-2532) Click: www.usaclean.com Fax: 1-888-USA-CLEAN (888-872-2532)
Windsor Sensor
Replacing the Brush Roller and/or Belt
These are general maintenance guidelines.
Please consult your owner’s manual prior to performing any repairs or maintenance on this machine.
**
Before you begin:
Turn the machine off and unplug it.
1.
Push the button
on the front of the
vacuum body to
release the body
from the base.
2.
Pull the body up
to remove it from
the base.
3.
Push the button
on top of the base.
While holding the
button down, pop
the brush roller
cover off.
4.
Pull to remove
the brush roller
cover.
5.
Pull the brush
roller through
the opening to
remove.
6.
Reverse process
to install a new
brush roller or
continue to step 7
to replace the belt.
7.
With brush roller
pulled out, flip
the base over and
using a Phillips
screwdriver,
remove the 4
screws from the
base plate.
8.
Flip the base
back over and pull
to remove the top
base cover.
Tools Needed
A.
Flat tip
screwdriver
B.
Phillips
screwdriver