Wind WD25TC-IN, Operation Manual

Page: 6 / 36

Operation
Sleep Operation
Pre Press
SLEEP
button to enter sleep funct ion
Note
When TIMER function is set, the sleeping function can’t be
set up .After the sleeping function is set up
,
if user resets
TIMER function, the sleeping function will be cancelled; the
machine will be in the state of timing-on.
TURBO/QUIET Operation
When you need rapid heating or cooling, you can use TURBO function.
When silence is needed for rest or reading,you can use QUIET function
Press
TURBO/QUIET
button, the remote controller will show
and then achieve to the TURBO function. Press again this
,
TURBO/QUIET
button, the remote controller will show button, th
and then achieve to the QUIET function. Press again this
TURBO/QUIET
button , the QUIET function will be cancelled.
SLEEP operation starts SLEEP operation stops
Approx.6hrs
Note
During TURBO operation, in rapid HEAT or COOL mode ,
the room will show inhomogeneous temperature distribution.
Long period QUIET operation will cause effect of not too
cool or not too warm.
1 hr
Rises 1 O C
1 hr
Rises 1 O C
Temp.setting
Unit stop
In COOL, DRY mode
In HEAT mode 2.
1 hours after SLEEP mode starts,temp will become 2
O
C
lower than temp.setting.After another 1 hours,temp
decrease by 2
O
C futher.After more another 3 hours,temp.
rises O
C
by 1 futher.The unit will run for further 3 hours then
stops.Temp.is lower than temp. setting so that room
temperature won’t be too high for your sleep.
Temp.setting Unit stop
1 hr
Decreases 2
O
C
1 hr
Decreases 2
O
C
3 hrs
3 hrs Rises 1
O
C
SLEEP
SLEEP
operation starts
operation stops
In HEAT mode
3. In SMART mode
The unit operaters in corresponding sleep mode
adapted to the automatically selected operation mode.
3
4. In FAN mode
It has no SLEEP function.
5.Set the wind speed change when sleeping
If the wind speed is high or middle before setting for the
sleep, set for lowing the wind speed after sleeping.
If it is low wind, no change.
HEALTH Operation
(This function is unavailable on some models.)
Press Pre
EXT
s
RA
F
s
UNCTION
button to enter additional options, when
cycle display to cycle di , will flash. And then press CONFIRM
CANCEL
enter to health function.
The anion generato r in the airconditioner can generate
a lot of anion effectively balance the quantity of position
and anion in the air and a
●
lso to kill bacteria and speed
up the dust sediment in the room and finally clean the
air in the room.
Operation Mode
1 .. In COOL, DRY mode
1 hours after SLEEP mode starts,temp.will become 1
O
C
higher than temp.setting.After another 1 hours,temp.rises
O
C by 1 futher.The unit will run for further 6 hours then stops
T emp. is higher than temp.setting so that room temperature
won’t be too low for your sleep.