Wincor Nixdorf TH200, Programmer'S Manual

Page: 40 / 106

Programmer’s Guide
TH200
40
FS p n m Print NV bit image
Code:
Range:
Description:
Notes:
Reference:
ASCII FS p n m
Hex 1C 70 n m
Decimal 28 112 n m
1
≤
n
≤
255
0
≤
m
≤
3, 48
≤
m
≤
51
Prints a NV bit image n using the mode specified by m.
m Mode Vertical Dot Density
(DPI)
Horizontal Dot
Density (DPI)
0.48 Normal 180 203
1.49 Double-width 180 101
2.50 Double-height 90 203
3.51 Quadruple 90 101

n is the number of the NV bit image (defined using the FS q command).

m specifies the bit image mode.

NV bit image means a bit image which is defined in a non-volatile memory by FS q and
printed by FS p .

This command is not effective when the specified NV bit image has not been defined.

In standard mode, this command is effective only when there is no data in the print
buffer.

This command is not affected by print modes (emphasized, double-strike, underline,
character size, white/black reverse printing, or 90° rotated characters, etc.), except
upside-down printing mode.

If the downloaded bit-image to be printed exceeds one line, the excess data is not
printed.

This command feeds dots (for the height n of the NV bit-image) in normal and
double-width modes, and (for the height n × 2 of the NV bit-image) in double-height and
quadruple modes, regardless of the line spacing specified by ESC 2 or ESC 3 .

After printing the bit image, this command sets the print position to the beginning of the
line and processes the data that follows as normal data.
ESC *, FS q, GS /, GS v 0